B&T Print-XH RBS 5.56 Ti Subcompact Suppressor – Gray

B&T Print-XH RBS 5.56 Ti Overview

The B&T Print-XH RBS 5.56 Ti Subcompact in Gray is a 3D-printed titanium 5.56 suppressor with an Inconel 718 blast baffle and B&T's Reduced Backpressure System (RBS). It is built for AR-15 and M4-type rifles, including short-barreled hosts, with B&T listing no barrel length restriction.

Specifications

Key features

• Reduced Backpressure System limits bolt speed increase to under 2% on M4 carbines.
• Low-flash end cap and weldless hybrid titanium/Inconel construction.
• 1.375x24 HUB rear interface with 1/2x28 direct thread mount included.

FAQ

Can I run it on a short-barreled AR?

Yes. B&T lists no barrel length restriction for the Print-XH RBS, and the subcompact version is sized for PDW and short AR builds.

Can I use a QD mount instead of direct thread?

Yes. The rear end is a standard 1.375x24 HUB interface, so HUB-pattern QD adapters from other systems can be used in place of the included 1/2x28 mount.

Is this an NFA item?

Yes. Suppressors are regulated under the National Firearms Act and transfer on an approved ATF Form 4. Moriarti Armaments is a licensed FFL/SOT dealer and can handle your transfer.

See all 5.56 / .223 suppressors at Moriarti Armaments.

FAQ

Who makes it?

B&T USA.

Is this an NFA item?

Yes. Suppressors and short-barreled rifles are regulated under the National Firearms Act, and all NFA rules apply before transfer. Moriarti Armaments is a licensed FFL/SOT dealer; contact us for the current transfer process.

Related: Suppressors · Guns

Images may not be an exact representation of the product.